Removal

REMOVAL





1. Open hood.
2. Disconnect and isolate the battery negative cable.
3. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on the wiper arm nut cap and remove.
4. Remove wiper arm retaining nut.
5. Remove the arm from the pivot using a rocking motion while the arm is in an over/centered position.




6. Remove the right cowl cover.
a. Remove the rear engine compartment seal at the cowl.
b. Remove the four push retainers to the right side cowl cover and remove from vehicle.
7. Remove three reservoir retaining screws.
8. Disconnect the pump wire connector.
9. Disconnect the washer hose connections.
10. Lift washer reservoir out of cowl area and drain into bucket.
11. Remove plastic strap from around pump.
12. Gently pry pump away from reservoir and out of grommet. Care must be taken not to puncture reservoir.
13. Remover rubber grommet from reservoir.