Transmission Oil Cooler - Installation

INSTALLATION

Non - Turbo

1. Install transmission oil cooler and tighten screws to 8 Nm (70 in. lbs.).

NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.

2. Replace automatic transmission cooler hoses and clamps.
3. Connect hoses to cooler.
4. Install front fascia Front Fascia - Installation.
5. Start engine and check transmission fluid level. Adjust level as necessary.

Turbo

NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.

1. Replace automatic transmission cooler hoses and clamps.
2. Connect lines to cooler Transmission Oil Cooler Lines.
3. Install transmission oil cooler and tighten screws to 8 Nm (70 in. lbs.).
4. Install radiator closure panel center brace.
5. Install upper radiator closure panel Installation.
6. Install grille Grille - Installation.
7. Start engine and check transmission fluid level. Adjust level as necessary.