Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2008 >> Pacifica V6-4.0L >> Repair and Diagnosis >> Body and Frame >> Frame >> Cross-Member >> Rear Cross-Member Bushing >> Service and Repair >> Rear Crossmember Isolator - Installation >> Spring Link
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Spring Link







INSTALLATION





1. Position bushing (1) over rear of crossmember bushing bore.
2. Assemble tools over bushing and crossmember as shown. Ensure Receiver, Special Tool 9032-3 (4), is positioned to avoid welds on rear of crossmember bushing bore.
3. Using hand tools, tighten Press screw-drive, pressing bushing into crossmember. Install bushing until screw-drive stops, when bushing contacts Receiver on opposite side of crossmember.
4. Remove tools.




5. Swing spring link (3) up to bushing in crossmember (1) and install bolt and nut (4) fastening spring link to crossmember. Do not tighten bolt at this time.
6. Install rear spring as well as all components necessary to access it. Rear Hub / Bearing - Installation
7. Lower vehicle.
8. Position vehicle on alignment rack/drive-on hoist. Raise vehicle as necessary to access mounting bolt.
9. Tighten spring link bolt at crossmember to 109 Nm (80 ft. lbs.) torque.
10. Perform wheel alignment. Service and Repair
pro multis · About Operation CHARM