Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 2008 >> Sebring Sedan V6-3.5L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Service and Repair >> Removal and Replacement >> Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Installation







INSTALLATION





1. Install new O-ring onto PTU.
2. Apply RTV, 05010884AA, to the PTU O-ring.




NOTE: The sequence below should always be followed when installing the PTU

3. Install PTU into position.
4. Install PTU-to-transmission adaptor bolts (2) and tighten to 22 Nm (30 ft. lbs.).
5. Check and adjust PTU Fluid level. The PTU holds.8L (1.7 Pints.) of Mopar(R) 75W-90 Gear and Axle Lubricant.




6. Install the PTU Heat shield (3).
7. Install PTU-to-transaxle mount bracket upper bolts (1) and tighten to 54 Nm (40 ft. lbs.).




8. Install the lower heat shield bolt (2) and tighten to 22 Nm (30 ft. lbs.).




9. Install transmission rear mount bolts (2) and tighten to 54 Nm (40 ft. lbs.).
10. Install propeller shaft assembly. Propeller Shaft - Installation
11. Install exhaust to engine Catalytic Converter - Installation.
12. Install the crossmember Service and Repair.
13. Install right halfshaft assembly. Half Shaft - Installation
pro multis · About Operation CHARM