Rear Control

INSTALLATION





1. Position the rear A/C-heater control (1) to the rear overhead console (3) and align the control to the two plastic guide posts on the top of the console.
2. Install the two screws (4) that secure the rear A/C-heater control to the rear overhead console. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (2) to the back of the rear A/C-heater control.
4. Install the rear overhead console.
5. Reconnect the negative battery cable.
6. Calibrate the A/C-heater controlHVAC Actuator Calibration Procedure.