Intrusion Transceiver Module (ITM)

B222A-VEHICLE LINE MISMATCH

For a complete wiring diagram, refer to the wiring information Electrical Diagrams.

- When Monitored:
Anytime the ignition key is in the ON position.

- Set Condition:
If the Intrusion Transceiver Module (ITM) is not configured.





CONFIGURE THE INTRUSION TRANSCEIVER MODULE
1. Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.
2. With the scan tool, clear DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read DTCs.

Does the DTC reset?

Yes

- Replace the Intrusion Transceiver Module.
- Perform the BODY VERIFICATION TEST Body Verification Test.

No

- Test complete.
- Perform the BODY VERIFICATION TEST Body Verification Test.