Dynamics Sensor - Removal

REMOVAL





1. Disconnect and isolate the battery negative cable from its battery post.
2. Remove the instrument panel center stack console. Instrument Panel Bin - Removal





3. Roll back the front floor carpet from under the instrument panel toward the rear of the vehicle for access to components. Carpet - Removal
4. Remove the fasteners (2), then instrument panel center support brackets (2). There is one bracket on each side of tunnel structure.





5. Disengage the right intermediate floor distribution duct (2) from the stud located on the floor support (3) and move it aside as necessary to access the dynamics sensor.





6. Disconnect the wiring harness connector (3) at the dynamics sensor (2).
7. Remove the screws (1) mounting the dynamics sensor to the mounting bracket on the floor pan tunnel (4).
8. Remove the dynamics sensor (2).