Heated Seat Module - Installation

INSTALLATION

CAUTION:
Properly align the Heated Seat Module (HSM) retaining tab to the hole in the seat pan, prior to engagement. Failure to follow these instructions may result in damage to the plastic HSM housing and retaining tab.

CAUTION:
When equipped with a leather wrapped heated steering wheel and replacement of a Heated Seat Module (HSM) is required, the new HSM must be manually configured with a scan tool. Failure to follow these instruction may result in damage to the heated steering wheel.





1. Position the Heated Seat Module (HSM) (3) to the seat pan (1) and connect the wire harness connector (4).

2. Align the HSM retaining tab (2) to the hole in the seat pan and engage the retaining tab to the seat. Firmly apply even pressure to the HSM until the retaining tab is fully engaged.

3. Reconnect the negative battery cable.

4. When equipped with leather wrapped heated steering wheel, use a scan tool and configure the HSM Programming and Relearning.