Clutch Switch: Testing and Inspection

Clutch Switch Test (Manual Transmission Only)

Refer to Speed Control Wiring Diagrams. Prior to performing any tests, ensure servo or valve body and electronic module are properly tested.

Fig. 2 Speed control wiring diagram. 1980-84 Vans, Wagons & Front Sections:

Fig. 3 Speed control wiring diagram. 1981-84 Ramcharger, Trail Duster & Conventional Cabs:

Fig. 4 Speed control wiring diagram. 1982-84 Rampage & 1983 Scamp:

Fig. 5 Speed control wiring diagram. 1984 Mini-Vans/Wagons (1985 similar):

Fig. 6 Speed control wiring diagram. 1985 Conventional Cabs & Ramcharger:

Fig. 7 Speed control wiring diagram. 1985 rear wheel drive Ram Van & Wagons:

Fig. 8 Speed control wiring diagram. 1986-87 Conventional Cabs & Ramchargers:

Fig. 9 Speed control wiring diagram. 1986 rear wheel drive Ram Van & Wagons:

Fig. 10 Speed control wiring diagram. 1986 Mini-Vans/Wagons:

Exc. 1986-87 Mini-Vans/Wagons

1. Disconnect double connector at switch pigtail, then connect a 12 volt power source to either end of switch terminal.
2. Connect a suitable test light to remaining terminal end and ground.
3. Test light should be "on" when pedal is in normal position and "off" when pedal is depressed.
4. If above step is not as specified, replace clutch switch.