Axle Assembly, Replace

1. Disconnect battery ground cable, then secure brake pedal in the up position.
2. Raise and support vehicle , then disconnect front driveshaft at drive pinion yoke.
3. Disconnect drag link at steering knuckle arm (left side only).
4. Disconnect and plug brake line at frame crossmember.
5. Disconnect shock absorbers at lower mounts then disconnect sway bar link assembly, if equipped, from spring plates.
6. Disconnect vacuum lines and electrical connector from disconnect housing assembly if equipped.
7. Remove nuts and washers from U-bolt spring clips, then remove axle from vehicle.
8. Reverse procedure to install axle assembly. Lubricate all fittings, free brake pedal and bleed brakes.
9. Lower vehicle and check front wheel alignment.