Removal

Fig 2 Removing Or Installing (Allen Head) Key Retaining Screw:

1. Block brake pedal in the up position.
2. Raise vehicle to a comfortable working height and install jack stands.
3. Remove wheel and tire assembly.
4. Remove key retaining allen screw holding caliper to adaptor.

Fig 3 Removing Caliper Lock And Spring:

5. Tap adaptor lock and spring from between caliper and adaptor.
6. Carefully separate caliper from adaptor.
- Hang caliper out of the way.
- Do not allow caliper to hang or be supported by hydraulic brake hose.
- Inner brake shoe will remain on adaptor.

Fig 4 Removing And Installing Snap Ring:

7. Remove hub cap. Using Tool C-4020, or equivalent, remove snap ring.
8. Remove flange nuts and lockwashers.
9. Remove drive flange and discard gasket.

Fig 5 Removing Or Installing Outer Lockout:

10. Straighten tang on lock ring and using Tool DD-12414D or equivalent, remove outer locknut, lock ring, inner locknut and outer bearing.
11. Carefully slide hub and rotor assembly from spindle.