A.Engine Compartment Harness Pn 4362295

1. Disconnect the battery.

2. Remove engine side of bulkhead connector. Depress fingers on instrument panel half of bulkhead connector, and push connector back through the hole into the passenger compartment.

FIGURE 1A - ENGINE COMPARTMENT WIRING:

3. Remove engine cover. Install the bare eyelet terminal of overlay harness, PN 4362295, to the negative terminal of the ignition coil as shown in Figure 1-A.

FIGURE 1B - ENGINE COMPARTMENT WIRING:

4. Route and secure the engine overlay harness, PN 4362295, along the existing main engine wiring harness using the existing wiring clips and two tie wraps, PN 6015756 (Figure 1-B).

FIGURE 1C - ENGINE COMPARTMENT WIRING:

5. Route and secure the engine overlay harness, PN 4362295, along the existing headlamp-to-dash main engine wiring harness to the bulkhead connector using the existing wiring clips and three tie wraps, PN 6015756 (Figure 1-C). Loop and tape any excess wire of the engine overlay harness.

FIGURE 1D - TERMINAL END OF BULKHEAD CONNECTOR (ENGINE COMPARTMENT SIDE):

6. Coat the bare blade terminal of the engine overlay harness, PN 4362295, liberally with Mopar multi-purpose grease PN 4318063, and snap into cavity #14 of the engine side of the bulkhead connector (Figure 1-D).