A.Engine Compartment Harness Pn 4362295

ENGINE COMPARTMENT WIRING:

A. Engine Compartment Harness PN 4362295

1. Disconnect the battery.

2. Remove engine side of bulkhead connector. Depress fingers on sides of instrument panel half of bulkhead connector, and push connector back through hole into the passenger compartment.

3. Install the bare eyelet terminal of overlay harness, PN 4362295, to the negative terminal of the ignition coil as shown in Figures 1-B and 1-C.

4. Route and secure the overlay harness, PN 4362295, along the existing headlamp-to-dash main wiring harness to the bulkhead connector using the existing wiring clips and six tie wraps, PN 6015756, as shown in Figure 1-A. Loop and tape any excess wire of the overlay harness as illustrated.

5. Coat the bare blade terminal of the overlay harness liberally with Mopar General Multi-Purpose Grease, PN 4318063, and snap into cavity #39 (cavity #27 for 1981 model year vehicles only) of the engine side of the bulkhead connector (Figure 1-D).