11C Fuel Injector Control Wire to Power Module

1. With [1][2]power module 10 terminal electrical connector and injector electrical connector disconnected, connect an ohmmeter between power module connector terminal No. 5 and tan wire connector terminal of injector connector.
2. If ohmmeter indicates continuity, replace [1][2]power module.

CAUTION: Before replacing the [1][2]power module check the terminals in cavities 5 and 7 of the 10-way connector to make sure they are not spread apart causing a poor connection.

3. If ohmmeter does not indicate continuity, check wiring from [1][2]power module connector terminal No. 5 to injector for open circuit.