Crankshaft Position Sensor: Service and Repair

Crankshaft Sensor:

REMOVAL



1. Disconnect the crank position sensor pick-up lead at the wiring harness connector.
2. Remove crank position sensor retaining bolt.
3. Pull crankshaft position sensor straight out of the transaxle housing.

INSTALLATION

1. Install sensor in transaxle and push sensor down until contact is made with the transaxle housing. Hold in this position and install and torque the retaining bolt 145 lb.in. (16.3 Nm.).
2. Connect crank position sensor lead wire at wiring harness connector.