Undeployed Module

WARNING: Before attempting to diagnose, remove or install any airbag system components, unless otherwise noted, you must first disconnect and isolate battery ground cable. Failure to do so could result in accidental deployment and possible personal injury.

WARNING: If replacing a deployed module, wear gloves and eye protection. There will be deposits on and around the airbag that could cause skin and eye irritation. If material does come into contact with the body, flush with plenty of cold water.

Fig. 177 Airbag Module Attaching Screws - Removal:

NON DEPLOYED PASSENGER SIDE AIRBAG
1. Disconnect and isolate battery ground cable. Wait minimum of 2 minutes before working on vehicle.
2. Open glove box and push side inward to allow door bumper to pass and allow box to open fully.
3. Remove the four module attaching screws from inside glove box opening.
4. Remove knee bolster and right spot cooler.
5. Disconnect wire connector from module.
6. Lift module up and turn it so it can be lowered through the mounting brackets.
7. Reverse procedure to install.