Oil Filter: Service and Repair

Engine Oil Filter And Antidrain Back Valve:

OIL FILTER ANTI-DRAIN BACK VALVE
Installation: Apply liquid (Teflon Type) sealant to valve-to-block threads. Tighten assembly to 55 N-m (40 ft. lbs.).

FILTER REPLACEMENT

CAUTION: When servicing the oil filter, avoid deforming the filter can by installing the removal/install tool band strap against the can-to-base lock seam. The lock-seam joining the can to the base is reinforced by the base plate.

1. Using Tool C-4065, turn filter counter-clockwise to remove from base. Properly discard filter.
2. Wipe base clean, then inspect gasket contact surface.
3. Lubricate gasket of new filter with clean engine oil.
4. Install new filter until gasket contacts base. Tighten filter 1 turn or 20 N-m (15 ft. lbs.). Use filter wrench if necessary.
5. Start engine and check for leaks.