Tightening Specifications

Component Torque (Ft. Lbs.)

Camshaft Bearing Cap Nut 18
Camshaft Sprocket Bolt 65
Clutch Housing Strut 70
Connecting Rod Bearing Cap Nut 40 [02]
Crankshaft Sprocket Bolt 85
Cylinder Head Cover Bolt 9
Cylinder Head Bolt [04]
Exhaust Manifold Nut 17
Engine Mount Insulator Support To Assembly Bolt 40
Engine Mount Insulator To Crossmember Bolt 30
Engine Mount Through Bolt 50
Front Crankshaft Oil Seal Retainer Screw 9
Fuel Filter Mounting Bolt 9
Fuel Filter Pump Locknut 40 [01]
Fuel Filter Hose Clamps 10 [01]
Intake Manifold Bolt 17
Intermediate Shaft Retainer Screw 9
Intermediate Shaft Sprocket Bolt 65
Main Bearing Cap Bolt 30 [02]
Oil Pan Drain Plug 20
Oil Pan Bolts 17 [03]
Oil Pump Cover Bolts 9
Oil Pump Mounting Bolts 17
Oil Pump Strainer To Cover Screw 21
Oil Pump Strainer To Main cap Screw 9
Rear Crankshaft Oil Seal Retainer Screw 9
Spark Plug 20
Thermostat Housing Screw 21
Timing Belt Cover Bolts 40 [01]
Water Pump Housing Screw (Lower) 40
Water Pump Housing Studs (Upper) 21

[01] -- Inch lbs.
[02] -- After reaching specified torque, turn an additional 1/4 turn to achieve proper tightness.
[03] -- M6 screws, 105 inch lbs.,
M8 screws, 200 inch lbs.

[04] -- Tighten cylinder head bolts as follows:
1st, torque to 45 ft. lbs.,
2nd, torque to 65 ft. lbs.,
3rd, turn head bolts an additional 1/4 turn.