Repair Procedure C

This Repair Procedure clamps three RFl filters around the intermittent wiper module's wiring.

1. Record the radio station presets.

2. Disconnect and isolate the battery negative cable.

3. Remove the five screws that secure the knee bolster to the dash pane! and remove the knee bolster.

4. Locate the intermittent wiper module located under the instrument panel and above the accelerator pedal. Slide the module off its mounting bracket.

5. Separate the nine wires entering the connector on back of the module into three groups. Install a snap-together filter on each of the three groups of wires. The filter should be placed as close to the module as possible.

6. Apply foam tape (P/N 4318028) around the RFI filters.

7. Slide the module back onto its mounting bracket.

8. Install the knee bolster.

9. Connect the negative cable and reset the clock and reprogram the radio to the station presets identified in step one.