Front

1. Raise and support vehicle, then remove wheel and tire assembly.

Fig. 252 Front Wheel Speed Sensor Assembly:

2. Remove screw from clip that retains sensor wiring grommet, then pull sensor grommet from fenderwell.
3. Disconnect electrical connector, then remove two screws retaining sensor wiring routing tube.
4. Remove sensor head screw, then the sensor head from steering knuckle.

NOTE: If sensor head is seized, use a punch and gently rock sensor back and forth until free. Do not use pliers on sensor head.

5. Reverse procedure to install. Coat sensor with suitable high temperature E.P. grease and torque mounting bolt to 5 ft. lbs.