Instrument Cluster Bezel Replacement

REMOVAL AND INSTALLATION

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. If the vehicle is equipped with an automatic transmission, turn the ignition switch to the Unlock position, set the parking brake, and place the automatic transmission gear selector lever in the Low position.
3. If the vehicle is so equipped, set the tilt steering column in its lowest position.

Cluster Bezel Remove/Install:

4. Using a trim stick or another suitable wide flat bladed tool, gently pry around the perimeter of the cluster bezel to disengage the nine snap clip retainers that secure the bezel to the instrument pane.
5. Pull the cluster bezel away from the instrument panel far enough to access and unplug the wire harness connector from the back of the fog lamp switch delete plug or, if the vehicle is so equipped, the fog lamp switch.
6. Remove the cluster bezel from the instrument panel.