Installation

NOTE: When assembling exhaust system do not tighten clamps until components are aligned and clearances are checked.





1. Assemble catalytic convertor to exhaust manifold ball joint connection.
2. Assemble exhaust pipe to catalytic convertor and the support to the underbody
3. Install the muffler to exhaust pipe and the supports to the underbody.
4. Working from the front of system;
5. Align and tighten the catalytic convertor to exhaust manifold ball joint bolts.





6. Align each component to maintain position and proper clearance with underbody parts and tighten clamps to specification.
7. Connect the downstream heated oxygen sensor.





8. A new style band clamp (Torca) will be used on this vehicles exhaust system.