RKE Programming

To enter programming mode:

1. Disarm Electronic Entry Module (EEM).
2. Ground Pin C13 of EEM J3 connector (6 inch green pigtail wire located at the EEM).
3. Turn ignition switch to the RUN position.

To Program Transmitter

Alarm Set LED:

1. Receiver acknowledges programming mode by the flashing Alarm Set LED located on the top, center of the instrument panel.
2. Send transmitter code by pressing either button on the transmitter for approximately 10 seconds. A successful programming will be acknowledge with a triple horn chirp. Repeat for both transmitters. All transmitters MUST be reprogrammed at this time

NOTE: Program mode will time out If no valid transmitter code is received within 60 seconds. The timer resets after each successful transmitter programming.