Body Control Module: Service and Repair

Battery Negative Cable:

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove lower steering column cover and knee blocker reinforcement.
3. Disconnect two wire connectors from bottom of Body Control Module (BCM)

Body Control Module Location:

4. Remove bolts holding Junction Block to dash panel mounting bracket.
5. Remove Junction Block from mounting bracket.
6. Remove screws holding Body Control Module to Junction Block.
7. Slide Body Control Module downward to disengage guide studs on Junction Block from channels on BCM mounting bracket.
8. Remove Body Control Module from Junction Block.

INSTALLATION
For installation, reverse the above procedures.