Procedures

REAR DOOR WINDOW REGULATOR

REMOVAL
1. Remove upper door trim extension panel.
2. Remove door trim panel.
3. Position glass to access the fasteners. Remove the fasteners.
4. Disengage glass from regulator lift channel.
5. Position glass up into door frame (rest glass on a block of wood on door reinforcement).
6. Lower waterdam.
7. Disconnect regulator wire harness, if equipped.

Fig. 55 Rear Door Window Regulator - Manual:

Fig. 56 Rear Door Window Regulator - Power:

8. Remove screws attaching window regulator to door inner panel.
9. Remove window regulator from door.

INSTALLATION
1. Position window regulator in door.
2. Loosely install screws attaching window regulator to door inner panel.
3. Install glass onto regulator lift channel. Secure fasteners.
4. Connect regulator wire harness, if equipped.
5. Cycle the window glass to the full up position.
6. Tighten bolts attaching the regulator to the inner door panel.
7. Install waterdam.
8. Install door trim panel.
9. Install upper door trim extension panel.