Oil Pan: Service and Repair

REMOVAL

(1) Disconnect battery negative cable.
(2) Remove engine oil dipstick.
(3) Remove air cleaner inlet duct.
(4) Unbolt the engine controller from the cowl and secure out of the way DO NOT DISCONNECT.
(5) Remove upper cooling fan shroud fasteners.
(6) Remove engine cover.
(7) Raise vehicle on hoist.
(8) Drain engine oil.
(9) Remove transmission oil cooler lines from the oil pan mounting clip.
(10) Remove engine to transmission support braces.
(11) Remove starter motor.
(12) Remove transmission inspection cover.





Fig. 67





Fig. 68

(13) Remove left and right engine mount insulator nuts (Fig. 67) (Fig. 68).
(14) Remove the oil pan fasteners.
(15) Remove the oil pan from the vehicle. Note: The crankshaft may have to be rotated for the oil pan to clear the #1&2 journal counterweight on removal.

INSTALLATION





Fig. 69

(1) Fabricate four alignment dowels from 5/16 x 1 1/2 inch bolts. Cut the head off the bolts and cut a slot into the top of the dowel. This will allow easier installation and removal with a screwdriver (Fig. 69)





Fig. 70

(2) Install the dowels in the cylinder block (Fig. 70).
(3) Apply a small amount of MOPAR Silicone Rubber Adhesive Sealant, or equivalent in the corner of the cap and the cylinder block.
(4) Slide the one piece gasket over the dowels and onto the block.
(5) Position the oil pan over the dowels and onto the gasket.
(6) Install the oil pan bolts. Tighten the bolts to 24 Nm (215 in. lbs.).
(7) Remove the dowels. Install and tighten the remaining pan bolts to 24 Nm (215 in. lbs.).
(8) Install and tighten the oil pan drain plug to 34 Nm (25 ft. lbs.).
(9) Lower the engine while aligning the engine mount insulators with the brackets.
(10) Install the mount insulator nuts and tighten to 102 Nm (75 ft. lbs.).
(11) Install the transmission inspection cover.
(12) Install the starter motor.
(13) Install the engine to transmission support brackets.
(14) Install the transmission oil cooler lines into the mounting clips.
(15) Lower the vehicle.
(16) Install the upper cooling fan shroud.
(17) Fasten the controller to the cowl.
(18) Install the air cleaner inlet duct.
(19) Install the engine oil dipstick.
(20) Fill the crankcase with engine oil.
(21) Connect the battery negative cable.
(22) Start engine and check for leaks.