Rear

REM0VAL AND INSTALLATION
The rear high speed blower motor resistor is used only on models with the optional rear heater-A/C unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from the rear heater-A/C unit.

Ignition Run Relay Remove/Install:

3. Unplug the ignition run relay from the outboard relay wire harness connector, which is secured to the rear of the rear heater-A/C unit.
4. Install the ignition run relay by aligning the relay terminals with the cavities in the wire harness connector and pushing the relay firmly into place.
5. Reinstall the cover for the rear heater-A/C unit.
6. Connect the battery negative cable.
7. Test the relay operation.