Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2000 >> RAM 2500 Truck 2WD L6-5.9L DSL Turbo VIN 6 >> Repair and Diagnosis >> Cruise Control >> Cruise Control Servo Cable >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Cruise Control Servo Cable: Service and Repair

REMOVAL
1. Disconnect both negative battery cables at both batteries.
2. Remove cable/lever/linkage cover. Refer to Speed Control Servo Removal/installation.
3. Remove (disconnect) servo cable from servo. Refer to Speed Control Servo Removal/installation.

Servo Cable at Throttle Lever:




4. Using finger pressure only, disconnect end of servo cable from throttle lever pin by pulling forward on connector while holding lever rearward. DO NOT try to pull connector off perpendicular to lever pin. Connector will be broken.
5. Squeeze 2 pinch tabs on sides of speed control cable at mounting bracket and push cable rearward out of bracket.
6. Remove cable from vehicle.

INSTALLATION
1. Install (connect) end of speed control servo cable to speed control servo. Refer to Speed Control Servo Removal/installation.
2. Install cable through mounting hole on injection pump mounting bracket. Cable snaps into bracket.
3. Connect servo cable to throttle lever by pushing cable connector rearward onto injection pump bellcrank pin while holding lever forward.
4. Connect negative battery cables to both batteries.
5. Before starting engine, operate accelerator pedal to check for any binding.
6. Install cable/lever cover.
pro multis · About Operation CHARM