Power Window Switch: Service and Repair
REMOVAL AND INSTALLATION1. Disconnect and isolate the battery negative cable.
Power Window And Lock Switch And Bezel Unit Remove/Install:
2. Using a wide flat-bladed tool such as a trim stick, gently pry the upper edge of the switch bezel at the front and the rear to release the retainer clips that secure the switch bezel to the door trim panel opening.
3. Pull the switch and bezel unit away from the door trim panel opening far enough to access and unplug the wire harness connector.
4. Remove the power window and lock switch and bezel unit from the door trim panel.
5. Reverse the removal procedures to install. When installing the switch and bezel unit to the door trim panel opening, insert the rear of the bezel into the opening, then push down on the front of the bezel until the retaining tab snaps into place.