Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2002 >> Dakota 2WD V6-3.9L VIN X >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Electronic Brake Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Electronic Brake Control Module: Service and Repair

REMOVAL

NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new CAB. To program the CAB refer to the Chassis Diagnostic.

1. Disconnect battery negative cable.

Fig.5 Harness Connector Locks:




2. Release the CAB harness connector locks, and remove the harness connectors from the CAB.

Fig.6 Pump Motor Connector:




3. Disconnect the pump motor connector.

Fig.7 Controller Mounting Screws:




4. Remove screws attaching CAB to the HCU.
5. Remove the CAB.

INSTALLATION

NOTE: If the CAB needs to be replaced, the rear axle type and tire revolutions per mile must be programed into the new CAB. To program the CAB refer to the Chassis Diagnostic.

1. Place the CAB onto the HCU.

NOTE: Insure the CAB seal is in position before installation.

2. Install the mounting screws and tighten to 4 - 4.7 Nm (36 - 42 in. lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Connect battery.
pro multis · About Operation CHARM