RKE Transmitter Programming

Remote Keyless Entry Transmitter Programming

Transmitter Programming can be done using the DRB III scan tool or by the customer.

CUSTOMER PROGRAMMING

To enter the customer programming mode:
1. Disarm the Entry Module. Refer to Electrical, Vehicle Theft Security for disarming procedure.
2. Ground Pin C13 of the entry module J3 connector (6 inch green pigtail wire located at the entry module).
3. Turn ignition switch to the RUN position.

Fig. 2 Vehicle Theft/Security System Led:

4. Receiver acknowledges programming mode by the flashing Vehicle Theft Security System LED located on the top, center of the instrument panel.

NOTE: Program mode will time out If no valid transmitter code is received within 60 seconds. The timer resets after each successful transmitter programming.

5. Send transmitter code by pressing either button on the transmitter for approximately 10 seconds. A successful programming will be acknowledge with a horn chirp. Repeat for both transmitters. All transmitters MUST be reprogrammed anytime a new FOB is added.