Front

REMOVAL
1. Raise and support vehicle.





2. Remove bolt attaching sensor to the steering knuckle.
3. Remove clamps securing sensor wire to control arm and inner fender panel.
4. In engine compartment, disconnect sensor wire from harness and remove sensor.

INSTALLATION
1. Position sensor in the knuckle and install sensor attaching bolts. Tighten bolts to 21 Nm (190 inch lbs.).
2. Secure sensor wire retaining clamps to control arm and fender panel.
3. In engine compartment, connect sensor wire to harness connector. Make sure wire is routed away from hot or rotating underhood components.
4. Turn steering wheel back and forth to verify that wire is clear of steering and suspension components.
5. Remove supports and lower vehicle.