Evaporator Temperature Sensor / Switch: Service and Repair

REMOVAL
1. Remove and isolate the battery negative cable.
2. Remove the access panel from the passenger side of the HVAC housing below the glove box housing to gain access to the evaporator temperature sensor.

Fig.18 Evaporator Sensing Probe (Typical):

3. Remove the evaporator temperature sensor from the evaporator.
4. Disconnect the evaporator temperature sensor lead wire from the wiring harness.
5. Remove the evaporator temperature sensor from the HVAC housing.

INSTALLATION
1. Install the evaporator temperature sensor to the evaporator.
2. Connect the evaporator temperature sensor lead to the wiring harness.
3. Install the evaporator temperature sensor panel to the HVAC housing. Be sure to install the panel seal if seal is damaged replace as required.
4. Reinstall the battery negative cable to the battery.