Electric Coolant Pump Replacement

REMOVAL
1. Disconnect and isolate the battery negative terminal.
2. Drain the engine coolant.
3. Locate pump on right side rear of inner fender and unplug electrical connector.

Fig.9 Electric Coolant Pump:

4. Using spring clamp pliers remove both hose clamps from the electric coolant pump.
5. Using a twisting motion gently remove both hoses from the electric coolant pump.
6. Remove the electric coolant pump from its bracket by gently pulling pump toward front of vehicle. It is not necessary to remove pumps mounting bracket from vehicle.

INSTALLATION
1. Install the electric coolant pump by gently pushing the pump on to the pumps mounting bracket.
2. Using a twisting motion gently push both hoses on to the electric coolant pump.
3. Using spring clamp pliers install the hose clamps and secure the hoses to the pump.
4. Plug the electrical connector to the electric coolant pump.
5. Fill the cooling system.
6. Connect the battery negative terminal to the battery.