Cruise Control Vacuum Reservoir: Service and Repair
Fig. 5 Vacuum Reservoir Location:
REMOVAL
The vacuum reservoir is attached to the right-inner fender located below the right headlamp.
1. Remove right headlamp assembly. Refer to Headlamp Bulb Removal/Installation for procedures.
2. Disconnect vacuum line at reservoir.
3. The reservoir is attached with one bolt (upper). The lower ear at bottom of reservoir fits into an access slot on fender support. Remove mounting bolt and remove reservoir from vehicle.
INSTALLATION
The vacuum reservoir is attached to the right-inner fender located below the right headlamp.
1. Fit lower reservoir mounting ear into access slot on fender support.
2. Install upper bolt and tighten to 4 Nm (35 in. lbs.) torque.
3. Install vacuum line at reservoir.
4. Install right headlamp assembly. Refer to Headlamp Bulb Removal/Installation for procedures.