Circuit Breaker: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the end cap from the driver side end of the instrument panel. Refer to Body/Instrument Panel End Cap for the procedure.

Fig. 1 Circuit Breakers Remove/Install:

3. Unplug the circuit breaker from the fuseblock module (Fig. 1).

INSTALLATION
1. Install the circuit breaker by aligning its terminals with the cavities in the fuseblock module and pushing the circuit breaker firmly into place.
2. Connect the battery negative cable.
3. Test the circuit breaker/system operation.
4. Reinstall the end cap on the instrument panel. Refer to Body/Instrument Panel End Cap for the procedure.