Rear Blower Motor Power Module

REAR BLOWER MOTOR POWER MODULE

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the right quarter trim panel and right D-pillar trim panel from the quarter inner panel.

Rear Blower Motor Power Module:

3. Disconnect the rear HVAC wire harness connector from the rear blower motor power module.
4. Disconnect the rear blower motor pigtail wire connector from the rear blower motor power module.
5. Remove the two screws that secure the rear blower motor power module to the rear HVAC housing.
6. Remove the rear blower motor power module from the rear HVAC housing.

INSTALLATION
1. Position the rear blower motor power module into the rear HVAC housing.
2. Install the two screws that secure the rear blower motor power module to the rear HVAC housing. Tighten the screws to 2 Nm (17 in. lbs.).
3. Connect the rear blower motor pigtail wire to the rear blower motor power module.
4. Connect the rear HVAC wire harness connector to the rear blower motor power module.
5. Reinstall the right quarter trim panel and right D-pillar trim panel onto the quarter inner panel.
6. Reconnect the battery negative cable.