Power

REMOVAL
1. Lower front window approximately 2 cm (3/4 in)
2. Disconnect and isolate battery negative cable
3. Remove door trim panel.

Electrical Connector:

4. Disconnect electrical connector.

Glass Support:

5. Using wood wedge, tape or equivalent, secure glass in the up position.

Regulator Assembly Mounting:

6. Remove tape securing wire harness to regulator assembly.
7. Remove carrier plate bolts.

Regulator Assembly:

8. Disengage lift arm from glass guide rail and remove regulator assembly.
9. Remove four rivets attaching regulator to carrier plate and remove regulator.

INSTALLATION
1. Install regulator onto carrier plate and install new rivets.
2. Install regulator lift arm into glass guide rail and install regulator assembly.
3. Install carrier bolts and tighten to 10 Nm (89 in. lbs.).
4. Replace tape securing wire harness to regulator assembly.
5. Remove glass support.
6. Connect the electrical connector.
7. Connect battery negative cable.
8. Verify correct window operation.
9. Install trim panel.