Sunroof Motor/Module Calibration

CAUTION: There is no adjustment available for a normally operating sunroof. this procedure is used to set sunroof motor/ module to sunroof assembly timing.

Sunroof Guide Lock Position:

1. Manually push the sunroof guide assembly to the full forward position until it is locked into position. This is verified by attempting to push the guide assembly rearward.

NOTE: The guide rail will be raised above the U-frame assembly when in the lock position.

2. Remove the sunroof glass.

Sunroof Guide Guide Pivot:

3. Manually move the guide pivot inside the guide rail cam slot until it is centered between the etched timing marks on both rails.

Sunroof Motor/Module:

4. Verify that the white marking is visible in the new motor/module window. If the mark is not visible, connect a power source to the motor/module and cycle the switch until the motor/module is in the closed position (white mark in window).
5. Install the sunroof motor/module and verify proper sunroof operation.
6. Install the sunroof glass, leaving the retaining bolts loose.
7. Install the sunroof assembly into the vehicle.
8. Flush the sunroof glass into the vehicle roof opening and check sunroof glass alignment.