Front

REMOVAL
1. Remove the front wiper motor from vehicle.
2. Remove four backwall bolts and four brace nuts.
3. Remove wiper linkage from wiper module.
4. Disconnect wire connectors from back of wiper motor.
5. Remove wiper linkage from motor crank. DO NOT remove crank from motor.
6. Remove bolts holding wiper motor and remove motor.

INSTALLATION
1. Place wiper module on a suitable work surface.
2. Install wiper linkage into wiper unit.
3. Connect wire connectors to wiper motor.

Wiper Module Wire Connector:

4. Place the wiper module into engine compartment and connect wiper module wire connector to engine wire harness.
5. Install the four backwall bolts and four brace nuts to wiper module.
6. Operate wiper motor and verify that the wiper motor parks when wiper switch is turned OFF.