Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2006 >> Caravan V6-3.3L VIN R >> Repair and Diagnosis >> Wiper and Washer Systems >> Washer Fluid Level Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Washer Fluid Level Switch: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Hoist and support vehicle on hoist or jack stands.
3. If necessary, remove the right front wheel and tire assembly.
4. Disconnect the right front wheelhouse splash shield and move aside.
5. Drain washer fluid from the reservoir and into a suitable clean container. This can be done by disconnecting the windshield washer hose from the front (outboard) washer pump port allowing the washer fluid to drain into a container through a temporary jumper hose connected to the front washer pump.
6. Disconnect the electrical body harness connector to the the fluid level sensor. Slide the red lock on the connector to the release position, then, depress the black tab and pull the connector off the sensor.
7. Remove the sensor from reservoir by using a side foot to gently pry the sensor from the body of the reservoir. Do not damage the reservoir/sensor sealing surface or puncture reservoir during removal.

CAUTION: To avoid damage to the sensor, assure the reservoir is in an upright position before removing the sensor from the reservoir. Do not rotate the sensor during removal.

INSTALLATION
1. Use a new grommet when installing a new sensor assembly.
2. Assure that the flat of the sensor is aligned under the ridge of the reservoir and that the sensor connector is facing down in the fully seated position. This will allow for proper operation of the sensor float switch.
3. Connect the electrical body harness connectors to the fluid level sensor. Slide the red lock on the connector to the closed or locked position.
4. Assure that washer hose is properly routed to prevent pinching and possible inoperative washers.
5. Connect the left right front wheelhouse splash shield and move aside.
6. Install the right front wheel and tire assembly.
7. lower vehicle from hoist or jack stands.
8. Connect the battery negative cable.
9. Verify system operation.
pro multis · About Operation CHARM