Map Light Bulb: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Using a small thin-bladed screwdriver, gently pry the rear edge of the bezel (2) and the overhead console housing (4) to unsnap the bezel from the housing.
3. Using a small thin-bladed screwdriver, gently pry between the outboard edge of the lens (1) being removed toward the center of the vehicle until it unsnaps from the housing.
4. Remove the lens from the housing.




5. Carefully unsnap the bulb (2) from the two bulb holders within the overhead console lamp housing.

INSTALLATION

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket and/or the lamp wiring.




1. Align the ends of the bulb (2) with the two bulb holders within the overhead console lamp housing.
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.




3. Position the lens (1) to the overhead console housing (4) and snap the outboard edge back into place.
4. Position the forward edge of the bezel (2) between the two lenses, then press the rear edge of the bezel firmly and evenly until it snaps back into the housing.
5. Reconnect the battery negative cable.