Installation

INSTALLATION

FRONT COVER - UPPER

1. Install timing belt cover. Torque fasteners to 6 Nm (50 in. lbs.) (Figure 2).

FRONT COVER - LOWER

1. Install timing belt front covers (Figure 2). Tighten fasteners to 6 Nm (50 in. lbs.).
2. Install generator drive belt tensioner.
3. Install crankshaft vibration damper.

REAR COVER

1. Install rear timing belt cover and fasteners. Torque fasteners to specified values (Figure 5).

CAUTION: Do not use an impact wrench for tightening camshaft sprocket bolt. Damage to the timing locating pin can occur. Hand tighten using a wrench ONLY.

2. Install camshaft sprockets. Hold sprockets with Special Tool 6848 and tighten center bolt to 101 Nm (75 ft. lbs.) (Figure 3).
3. Install timing belt idler pulley and tighten mounting bolt to 61 Nm (45 ft. lbs.) (Figure 4).
4. Install timing belt.
5. Install engine mount bracket and tighten bolts to 61 Nm (45 ft. lbs.) (Figure 1).
6. Install front covers.





Figure 1 Engine Mount Bracket











Figure 2 Front Timing Belt Covers











Figure 3 Camshaft Sprocket - Removal/Installation


1 - SPECIAL TOOL 6847






Figure 4 Timing Belt Idler Pulley











Figure 5 Rear Timing Belt Cover Fasteners