Front Heater Core Tubes - Installation

FRONT HEATER CORE TUBES - RG MODELS
1. Remove the plugs or tape from both heater core tube fittings and both heater core ports.

2. Position the heater core tubes and sealing plate to the dash panel, below the instrument panel.

3. Install both heater core tubes simultaneously through the dash panel seal.

4. Position both heater core tubes and the sealing plate simultaneously onto the heater core.

NOTE: The heater core tubes each have a slot that must be indexed to a location tab within each of the heater core ports. Adjust the position of the tubes as required so that the sealing plate fits flush against the heater core supply and return ports, which indicates that the tubes are properly indexed.

5. Index both heater core tubes to the heater core ports.

6. Install the bolt that secures the heater core tube sealing plate to the heater core. Tighten the bolt to 3 Nm (27 in.lbs.).

7. Install the silencer under the driver side end of the instrument panel. Service and Repair

8. Connect the heater hoses to the heater hose tubes.

9. Reconnect the negative battery cable. Service and Repair

10. Refill the engine cooling system. Service and Repair