Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions could result in possible personal injury or death.

1. Recover the refrigerant from the refrigerant system.

2. Remove the air cleaner housing from the right side of the engine compartment.

3. Remove the bolts that secure both liquid lines to the receiver/drier (Figure 1).

4. Disconnect both liquid lines from the receiver/drier and remove and discard the O-ring seals.

5. Install plugs in, or tape over the opened liquid line fittings and the receiver/drier ports.

6. Remove the two nuts that secure the receiver/drier mounting bracket to the weld studs on the side of the right front strut tower and remove the receiver/drier.






Figure 1 Receiver/Drier - LHD Shown, RHD Typical