Fluid Level Inspection
FLUID LEVEL INSPECTION
1. Raise vehicle on hoist.
2. Remove PTU inspection plug (Figure 1).
Figure 1 Inspection Plug
1 - INSPECTION PLUG
3. Fluid level should be within 3/16" from bottom of inspection hole. Add Mopar(R) Gear and Axle Lubricant 80W-90 as necessary with suitable suction gun (Figure 2).
Figure 2 Removing/Adding PTU Fluid
4. Install inspection plug and torque to 20 Nm (180 in. lbs.) torque.
5. Lower vehicle.