Installation

INSTALLATION

1. Use new grommet when installing a new pump assembly.

2. Assure pump upper retention tab is pressed into reservoir slot and that pump is rotated flat against the reservoir and that pump connector is facing up in the fully seated position. Assure the pump is aligned to and fully seated in the reservoir cavity.

3. Connect the electrical body harness connectors to the washer pump motor. Slide the red lock on the connector to the closed or locked position.

4. Assure that washer hose is properly routed to prevent pinching and possible inoperative washers.

5. Connect the left right front wheelhouse splash shield and move aside.

6. Install the right front wheel and tire assembly.

7. Lower vehicle from hoist or jack stands.

8. Connect the battery negative cable.

9. Verify system operation.