Installation

INSTALLATION




1. Fold the seat in a flat position and install the seat assembly to the rear studs.

2. Connect the electrical connector (3) to the seat module.

3. Install the anchor bolt to the seat belt (2), and tighten to 62 Nm (46 ft. lbs.).

4. Install the two seat bracket nuts (1) to the seat brackets and tighten to 62 Nm (46 ft. lbs.)

5. Install the seat bracket bolt (4) to the seat bracket and tighten to 62 Nm (46 ft. lbs.)





6. Install the four seat bracket bolts to the seat brackets and tighten to 54 Nm (40 ft. lbs.).





7. Install the three seat bracket nuts the seat brackets and tighten to 54 Nm (40 ft. lbs.).





8. Install the load floor panel (1) to the load floor (2) and the rear seat bracket (3). Use hand pressure to seat the clips.

9. Return the rear seats in the upright position.

10. Connect the negative battery cable to the battery.