Removal

REMOVAL





CAUTION: Do not attempt to remove the trim panel the conventional way. This door panel has hooks holding it to the door rather than push pins. The door module must be removed as an assembly. Carefully follow these instructions in order to prevent unnecessary damage to the trim panel.

1. Remove the trim panel. Refer to Trim Panel.





2. Remove the door plug (2).

3. Remove rear exterior handle nut (1).





4. Remove the inner door weatherstrip.





5. Remove the tape covering the access hole on the carrier plate and discard. Access the window regulator liftplate through the hole in the carrier plate.

6. Push down the door glass (1) and use a screw driver to release the tap on the window regulator liftplate (2). Lift the glass up and secure the to the header.





7. Remove the three screws (2) securing the door latch to the door shut face.

8. Remove the one screw (1) attaching the latch presenter to the door shut face.





9. Disconnect and remove the electrical connector (1) from the door (5).

10. Remove the rear exterior handle nut attaching the door handle to the latch presenter.

11. Remove the 10 screws (4) from the carrier plate (2).

12. Remove the carrier plate (2) from the door (5).





13. Remove the door glass from the module opening in the door.