B220A

B220A-OCCUPANT RESTRAINT CONTROLLER INTERNAL 4

- When Monitored:

With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.

- Set Condition:

This DTC will set if the module identifies an out of range internal circuit.





Diagnostic Test

1. REPLACE OCCUPANT RESTRAINT CONTROLLER

Turn the ignition on.

WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.

WARNING: If the Occupant Restraint Controller is dropped at any time, it must be replaced. Failure to take proper precautions could result in accidental airbag deployment and serious or fatal injury.

Repair

- Replace the ORC.
- Perform *AIRBAG SYSTEM VERIFICATION TEST - VER 1. Airbag System Verification Test